Ciao Mimmo 73' il cavetto sopra citato funziona benissimo e fa tutte le funzioni. Ho 2 ts480 uno sat e l'altro hx e mai avuto problemi, certo devi farli funzionare con il VOX ma vanno alla grande in tutti i modi digitali. Ti riporto quanto scrive un corrispondente spagnolo:
Dave AA6YQ asked me several times if i was using the Mic input or the DATA input and i kept insisting i was using the Mic input. And yes, i was, but i was using the Mic input of the PC, not of the radio!! On the radio i was using the DATA input.
Then Dave pointed me to a checkbox on the radio setup in Commander where you can select whether you use the Mic or the ANI input for data. I looked ANI up in the radio manual and that’s when my coin dropped. I was using ANI and not Mic. And that’s when everything started to work.
A couple of hints for setting up the radio and software for PSK
PSK31 running in WinWarbler
1. Set sound card sampling rate to 8000Hz This must be at least a 16 bit sound card.
2. No Signal observed? Check WAVE slider is not zero and check if you are using the right ports.
3. Set Rx and Tx frequencies to 1000Hz. This value will get you up and running but if you plan on using a filter change it to the center frequency. I currently use 2400Hz with a center of 1500Hz.
4. For PSK set your radio to USB.
5. If you get too much noise, consider using a narrow filter. My TS-480 has special filters for data use. Check if your radio has those as well and use those. If not, consider using a CW filter.
6. Your sound card output must NOT overdrive your Mic Input. Do not overdrive the sound card input from the Radio.
7. Do not use your Speech Processor.
8. Always check your ALC meter. MANDATORY that the ALC meter stays on 0!!!
9. ALC on 0.
10. ALC has to be on 0.
11. Read 8, 9 and 10 again.
10. Use to the Waterfall/Phase indicators for tuning. PSK works with channels. Channels are very small frequency ranges that all fall inside your filter, so you can hear them all. Make sure you know who you are talking to.
Ciao buona giornata
Mario
