KENWOOD TM-D700 E

Aperto da lucignolo, 25 Dicembre 2007, 01:07:14

Discussione precedente - Discussione successiva

0 Utenti e 1 Visitatore stanno visualizzando questa discussione.

lucignolo

salve !  come si attiva la funzione trasponder (gross band) su questo apparato  ? grazie


conte dracula

prova su mods.dk -> KENWOOD - TM-D700 ce ne sono almeno tre di articoli...purtroppo devi iscriverti .   forse ce ne sono altri di siti...auguri,buon natale.

conte dracula

allora....devi togliere la res.da zero ohm ,vicina alla scritta "repter",a fianco di quella "ch".....se vai sul sito di kb2ljj,trovi anche la foto...molto chiara....ciao :birra:

TheGuardian

73 A TUTTI
questa è l'operazione che devi fare per attivare il trasponder o "CROSS BAND" , tale funzione si attiva solo se è stata fatta la modifica , è in inglese ma si dovrebbe capire.
MIkele
TheGuardian

Repeater functions. D700A and also the D700E after the Mod.
     This transceiver is capable of receiving signals on one band and re-transmitting signals on the other band. This function repeats signals originating from one band, using the other band.
     A signal received on band A (VHF) is re-transmitted on band B (UHF). Similarly, a signal received on band B (UHF) is re-transmitted on band A (VHF).

     Access Menu 1-7-6 (REPEATER) and select Locked" band Repeater or Cross-band Repeater. The default is "OFF".

Locked-band Repeater
The transceiver always uses the same band to receive or transmit a signal as a repeater. Belore accessing Menu 1-7-6, select one band as the TX band and the other band as the control band.

Cross-band Repeater
If receiving a signal on the TX band, the transceiver switches the current RX only band to the TX band. Before accessing Menu 1-7-6, select the sarne band as the TX and control bands.

     If you need, you can cause this transceiver to rermain in the transmit mode for 500 ms after signals drop. Access Menu 1-7-5 (REPEATER HOLD) and select "ON".